“I was so worried about ordering my Murphy Door because it seemed
so complicated, and then… I got on the phone with Alijah. He was
so helpful and so professional. By the time we were done completing my
first purchase, I already started planning additional doors and perhaps
beds and shelves as well! If I would have known Alijah was there to
assist, I would have made my purchase ages ago.”
A Murphy Door® mechanical key lock, precision-matched to your hidden door system and built to the same standard as the door it secures. Made in the USA.
Trusted worldwide
5 stars: 0 (0%)
4 stars: 0 (0%)
3 stars: 1 (50%)
2 stars: 1 (50%)
1 star: 0 (0%)
J
Jrmatusze (Queen Creek, US)
Lock Bar Set - Standard 4'
Manual key issues
The manual key lock is ok but there should be better instructions or at least an attempt by the company to put the holes in the appropriate places for you in the frames. They install the lock so why not provide a template or something to where the holes should be. I understand the frame may need to move a bit but not that much that is why measurements are double checked.
H
Hans Volk (Oak Brook, US)
Strike Plate
Not easy to lineup the bottom plate on the threshold
Have Questions?
Meet with a Murphy Door Customer
Meet with one of our past customers over video to ask them any questions about their Murphy Door!
Heads up: Surface Mount overlays a
finished wall. Finish the drywall, paint, and trim around
the opening before install, or exposed studs will show.
Measure the width of the existing door jamb (green).
Measure the rough opening width, stud to stud.
Enter your existing door width below
Enter your rough opening width below
Enter a whole number of inches (0–199).
That’s outside our standard sizes.
Call 801-436-5918
for a custom order.
Measure the height
Measure from the floor to the top of the existing door jamb (not the
door-stop).
Measure the rough opening from the floor to the header.
Enter your existing door height below
Enter your rough opening height below
Enter a whole number of inches (0–199).
That’s outside our standard sizes.
Call 801-436-5918
for a custom order.
Choose your jamb depth
Measure the depth of the existing door jamb (edge to edge, green),
then pick the closest match.
Measure the wall thickness (drywall face to drywall face), then pick
the closest match.
Choose your door handing
Surface Mount is Out-Swing only. In-Swing isn’t available for
this mount type.
Your Door Measurements
(make these selections for a proper fit)
Before You Install: Finish Those Walls First
Surface Mount sits over a fully finished opening: drywall,
paint, and trim done, just like an existing doorway. If
you’re still mid-construction, finish those edges out
first, or the raw sheetrock and framing around the door will
stay visible once it’s mounted.