10% off site wide. Discount is applied at checkout to qualifying products and can't be combined with other offers, promotional gift cards, or previous purchases. Shipping, Warranties, and taxes excluded. Sale ends at 11:59pm PDT.
Heads up: Surface Mount overlays a
finished wall. Finish the drywall, paint, and trim around
the opening before install, or exposed studs will show.
Measure the width of the existing door jamb (green).
Measure the rough opening width, stud to stud.
Enter your existing door width below
Enter your rough opening width below
Enter a whole number of inches (0–199).
That’s outside our standard sizes.
Call 801-436-5918
for a custom order.
Measure the height
Measure from the floor to the top of the existing door jamb (not the
door-stop).
Measure the rough opening from the floor to the header.
Enter your existing door height below
Enter your rough opening height below
Enter a whole number of inches (0–199).
That’s outside our standard sizes.
Call 801-436-5918
for a custom order.
Choose your jamb depth
Measure the depth of the existing door jamb (edge to edge, green),
then pick the closest match.
Measure the wall thickness (drywall face to drywall face), then pick
the closest match.
Choose your door handing
Surface Mount is Out-Swing only. In-Swing isn’t available for
this mount type.
Your Door Measurements
(make these selections for a proper fit)
Before You Install: Finish Those Walls First
Surface Mount sits over a fully finished opening: drywall,
paint, and trim done, just like an existing doorway. If
you’re still mid-construction, finish those edges out
first, or the raw sheetrock and framing around the door will
stay visible once it’s mounted.
